Aaf-international Carbon Side Access Manuel d'utilisateur télécharger pdf

APC-3-122 - 1 -

AAF CARBON SIDE ACCESS FILTER HOUSING

INSTALLATION AND OPERATION INSTRUCTIONS

CAUTION… Review these instructions and all safety procedures with your safety officer.

INSTALLATION OF HOUSING

1. Be sure position of housing access door(s) and direction of airflow

is correct prior to connecting ductwork.

- A minimum of 3 feet clearance is recommended for filter change out -

2. The housing should be permanently connected to the ductwork by

welding, bolting, or riveting. The housing to ductwork connection

should be suitably sealed with caulk or gasket material to

preclude leakage.

3. Following installation of the housing, the system should be

“Vacuumed out” or “Blown-Down” to remove construction dust,

etc., before installing the filters.

INSTALLATION OF FILTERS

1. Leave the filters in the shipping cartons until transported to the

proper housing location. Do not unpack the filters until time of

installation. Unpack the filters taking care not to cause damage.

2. Open the housing access door by unlatching the positive pressure

trip lock latches. The housing door is hinged and can be swung

open completely.

3. There are no locking mechanisms for the pre-filter or the carbon

trays on the Carbon housing.

1 2

APC-3-122 - 1 - AAF CARBON SIDE ACCESS FILTER HOUSING INSTALLATION AND OPERATION INSTRUCTIONS CAUTION… Review these instructions and all safety p

APC-3-122 - 2 - 4. Load pre-filters into the housing insuring that the filters are installed in the correct position. When airflow is horizontal,

Pas de commentaire

Aaf-international Carbon Side Access Manuel d'utilisateur